Trap Mailer helps you to mail the received traps to the configured
addresses. To configure the trap mailing option, please follow
the steps given below:
Step 1 : Configure the Mail addresses
From the Trap Viewer, click Configure Mail to open
the Mail Configuration Wizard.
Specify the following and click Configure:
Subject: Subject of the mail
From: From address of the mail
To: To address of the mail. You can specify all the to addresses
as comma separated.
MailServer: Name of the mail server
Suppress KeyWord: This is an optional field. Specify the
key words (as comma separated), for which mails should not
be sent. In other words, no mails will be sent if the received
trap messages that contains the key words specified here.
Mail/Hr: Number of mails to be sent in one hour. Traps received
exceeding this number will not be mailed, but will be logged
if the logging option is enabled in the Trap Viewer.
The values specified here will be written on to an XML file.
When you click the Configure Mail button from the Trap Viewer
again, the values will be retrieved from the XML and will
be shown here.
Step 2 : Select the Enable Mailing check box. Selecting
this option will enable the Trap Viewer to send the received
traps by mail to the configured addresses.
Note: Configuring the mail addresses alone will not
send any mails. Only if the Enable Mail option is selected,
mails will be sent.
